RhB / Swiss Trains
http://www.rhb-grischun.ca/phpBB3/

Comparing BRAWA to MLGB
http://www.rhb-grischun.ca/phpBB3/viewtopic.php?f=4&t=3419
Page 1 of 1

Author:  HJM [ Mon Jun 03, 2019 8:52 am ]
Post subject:  Comparing BRAWA to MLGB

It was to be expected

First the F4051

Next the C 20x

MLGB is very consistent, if there's something that could be screwed up they will. X( X( X(

Author:  Keith Yundt [ Mon Jun 03, 2019 2:33 pm ]
Post subject:  Re: Comparing BRAWA to MLGB

How the (*&^ did they manage to bugger those up?? I thought they had all the Brawa molds? X_X

Author:  HJM [ Mon Jun 03, 2019 5:42 pm ]
Post subject:  Re: Comparing BRAWA to MLGB

I'm quite sure they have all the BRAWA moulds, but just because one has the moulds doesn't mean one can run the parts. What are the chances that the material they tried for those fine parts wasn't suitable? Or they just didn't want to spend the time to get the settings right? Getting it right is for those who have the time and are anal enough. (Regards from my 3D printing experiences)
OTOH if one has a product manager who considers each screw up an isolated case .... then it isn't a surprise that one would find a convenient work-around, never mind that it looks like crap. X( :ymdevil: :ymdevil:

Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/